1.0 Scope This test method uses pressure sensitive tape to determine the adhesion quality of platings, marking inks or paints, and other materials used in conjunction with Printed Boards. 1、范围本试验方法使用压敏胶带测定镀层、标记油墨或与印制板一起使用的油漆和其他材料。
3.0 Test Specimens Any preproduction. first article, Or production printed board. A minimum of three tests should be performed for each evaluation
任何试生产样品。第一件物品，或生产印刷板。每次评估至少应进行三次测试
4.0 Apparatus or Material 仪器或材料
4.1 Tape A roll of pressure sensitive tape 3M Brand 600 1/2 inch wide or a tape as described in(CID AA-113). Type 1 Class B, except that the tape may be clear 一卷3M 600压敏胶带 1/2英寸宽或如（CID AA-113）所述的3m胶带。类型1 B类，但磁带可能是清晰的
5.0 Procedure 流程
5.1 Test Press a strip of pressure sensitive tape, 50mm[2.0 in] minimum in length, firmly across the surface of the test area removing all air entrapment. The time between application and removal of tape shall be less than 1 minute. Remove the tape by a rapid pull force applied approximately perpen dicular(right angle) to the test area. An unused strip of tape must be used for each test.
Originating Task Group Rigid Board T M. Task Group (7-11d)
5.2 Evaluation Visually examine tape and test area for evidence of any portion of the material tested having been removed from the specimen. 评估-目视检查胶带和试验区域是否有证据表明试验材料的任何部分已从试样上移除。
5.3 Report The report should note any evidence of material removed by this test. 报告该报告应记录通过该试验移除的材料的任何证据。
6.0 Notes 记录
6.1 If plating overhang breaks off (slivers) and adheres to the tape, it is evidence of overhang but an adhesion failure 如果镀层悬垂断裂（碎片）并粘附在 胶带，它是悬垂的证据，但粘着失效.
6.2 If foreign material (oil, grease, etc. ) is present on the test surface the results may be affected not an adhesion failure 如果测试表面有异物（油、油脂等），则测试结果可能会受到影响，而不是粘着失效
